AR-15 Featherweight Bipod Installation
|
AR-15 Featherweight
Bipod |
 |
|
MAKE SURE YOUR RIFLE IS UNLOADED BEFORE STARTING |
|
 IMPORTANT: Fits ROUND mil spec handguards without modification. NOTE: Must drill additional hole in M-4 handguard liner. |
STEP #1 Remove lower
handguard. STEP #2 Insert the round threaded adapter thru hole in lower handguard. Align and install 5/16” sling swivel stud. STEP #3 Start 10-32 x 1/4" Allen Screw into the top of the mounting column with supplied Allen Wrench. STEP #4 Place the mounting column over the front sling swivel stud. Align the thru holes; then install and center the retaining pin. Tighten the Allen Screw. Install new 1/2” threaded sling swivel stud and tighten. STEP #5 Remove backing from Neoprene Pad. Align and affix to bipod mounting bracket. STEP #6 Align and install Bipod over the mounting column with legs parallel to the barrel and pointing toward muzzle. (Depress “Snap-N-Lock” button and rotate legs 180°) STEP #7 Place nylon washer over mounting column. Install mounting nut onto column and hand tighten plus 1/4 turn maximum. Failure to follow this procedure could result in damage to stock. Do Not Overtighten! STEP #8 Your Advanced Technology, Inc. Bipod is now in place and ready to use. STEP #9 To adjust legs forward, down, or rearward simply depress the “Snap-n-Lock” button and rotate leg to the desired location. Then release the button. STEP #10 To adjust height (inner leg) twist knurled thumbscrew 1/4 turn and legs will freely drop. Retighten thumbscrew. To retract legs simply invert rifle and repeat process. |