Gunsmithing Tools & Fixtures
By Cylinder & Slide
Specially Made to fit, this 17 piece screwdriver and tool set contains screwdrivers ground for the 1897 Winchester Shotgun.
BUY
By Cylinder & Slide
The Ruger screw driver set is custom ground to fit the screws on the NEW MODEL RUGER SINGLE ACTION revolvers. The narrow tip screwdriver fits the grip screw, the middle sized tip screwdriver fits the back strap and trigger guard screws, and the widest screwdriver tip fits the ejector tube screw. The screwdrivers will also fit most of the screws on the old style single action revolvers and the Old Army.
BUY
By Cylinder & Slide
The three screwdrivers in this set have been ground to fit the Colt single Action Army Pistols and the clones made by the various Italian Companies. The longest screwdriver fits the back strap, trigger guard, ejector tube, base pin , trigger and bolt screws. The middle size screwdriver fits the grip screw and the short screwdriver fits the hammer, mainspring and the trigger and bolt spring screws. These screwdrivers are ground to give full contact on the sides of the screw slot with minimal clearance to prevent marring of the screw slot. They are .020" smaller than the width of the screw slot to help eliminate the chance of scratching the frame. These screwdrivers are Made in the USA and are properly tempered for a life time of use.
BUY
Extractor
Rod & Yoke Alignment Tool
Quickly straighten and tests yoke Alignment on S&W K,L,N & Ruger "Six"
Series. Increases smooth operation of your revolver. The Extractor Rod & Yoke Aligner,
without the Dial Indicator.
Dial Indicator sold separately. Available through Brownells, Inc.
BUY
Hand
Fixture/Bench Block
This is a multi-purpose tool that greatly accelerates and simplifies disassembly
and reassembly of various revolvers. Additionally, the tool is designed for controlled
hand offsetting.
BUY
Once the yoke is square its easy to eliminate excessive yoke play by using the Power Yoke Bearings. Reamer fits the yoke I.D on S&W K, L, & N frames, Ruger Speed and Security Six.
BUY
Series I Stoning Fixture
Perform repeatable trigger jobs easily with this quality made fixture. There are 20
different adapters are available with this fixture.
Includes one Adapter of choice.
BUY
BUY
Precisely stone Hammers and Sears for most Semi-Autos on the market. There is 10 different adapters available for this fixture. The Universal Hammer adapter will allow you work on 20 different hammers alone. The Series II Stoning Fixture is a must for the do it your-selfer or serious gunsmiths. Includes one Adapter of choice.
BUY
Rail
Slide Clamp
Precisely tighten 1911 Auto Slides when used in conjunction with a Heavy Duty Vice. Stops
Are provided to prevent over tightening.
BUY
Rail
Spreaders
Easily spreads over tightened 1911 Auto Slides.
BUY
Frame
Support System
Helps to Eliminate Frame Damage while performing gunsmithing alterations. Also, Acts as a
guide for Stippling.
$73.55
BUY
(picture not available)
BUY
Hammer and Sear Blocks
Allows for exact examination of the sear & hammer engagement surfaces. Each base also
includes a hole for easy disassembly.
BUY
Can be used with or without the Frame Support System. Allows you to Checker the Front Strap or Mainspring Housing. May be used for 60 Degree or 90 Degree Checkering.
$9.99
BUY